A 40W LED canopy light is made for low ceilings: parking levels of 10 to 12 ft, garages and covered entrances. This guide covers the main 40W LED canopy light uses, how many you need and what one replaces. Each example shows the math, so you can rerun it for your own space.
40W canopy light specs at a glance
Here's what our 40W LED parking garage light (model PG02) is rated for, from its product page and spec sheet.
| Spec | 40W PG02 |
|---|---|
| Light output | 5,082 lumens (4000K) |
| Efficacy | 128 to 130 lumens per watt |
| Beam angle | 150° |
| Color temperature | 4000K |
| Color rendering | CRI 80+ |
| Input voltage | 120 to 277V |
| Weather rating | IP65, wet location |
| Operating temperature | −40°F to 113°F |
| Dimming | 0–10V, standard |
| Motion sensor | Listed; type, range and hold time not published [VERIFY] |
| Rated life | 50,000 hours |
| Listings | UL, cUL, DLC 5.1 Premium |
| Weight | 4.2 lb |
| Warranty | 5 years |
The 150° beam spreads about 5,100 lumens across a wide patch of floor instead of a bright spot. The wet rating and cold rating let it work in an unheated garage or under an open-sided canopy.
40W LED canopy light uses: where it works best
The PG02 product page lists parking structures, covered walkways, building and warehouse entrances, loading docks and commercial canopies. Here's how a 40W fits each one.
Parking garages with 10 to 12 ft ceilings
Low parking levels are where a 40W makes the most sense. A Bonneville Power Administration example lights an 11 ft garage with 66W LED fixtures of 4,945 lumens, one every 25 ft.
The 40W gives slightly more light on 26W less power, so you can plan on the same grid with about 39% less load. Our parking garage lighting range covers the other sizes for these ceilings.
Home and shop garages
At about 5,100 lumens, each 40W covers roughly 100 sq ft of garage at the common guideline of 50 lumens per square foot. Two other specs matter at home.
The 120 to 277V input range includes a standard 120V household circuit. The cold rating, down to −40°F, suits a detached or unheated garage.
Covered walkways, entrances and carports
Under a covered walkway, entrance or carport, the job is safe footing and a clear view of steps and faces. The wide beam spreads light along the path, and the wet rating handles rain blowing in from open sides.
Loading docks work the same way: the fixture sits under the dock canopy, sheltered but exposed to weather. With a compatible control, 0–10V dimming lets you run it lower during quiet hours.
When to step down or up
- Less light: for a small entrance canopy, the 25W canopy light gives 3,263 lumens.
- More light per fixture: for wider spacing or a brighter space, the 55W canopy light gives 7,054 lumens. The 60W LED canopy light gives 8,238.
- Tall warehouses and shops: from high up, a 150° beam spreads too thin, so UFO LED high bays are the better fit.
- Large gas station canopies: these usually need the higher-wattage models in our LED canopy lights collection.
How many canopy lights do I need?
With the 40W, divide the lumens a space needs by 5,082 (the 4000K rating). Round up, not down: the spec sheet allows a 10% lumen tolerance.
One-car garage, 12 × 24 ft
- Area: 12 × 24 = 288 sq ft
- Light needed: 288 × 50 = 14,400 lumens
- Fixtures: 14,400 ÷ 5,082 = 2.8, so three 40W lights (15,246 lumens)
Two-car garage, 24 × 24 ft
- Area: 24 × 24 = 576 sq ft
- Light needed: 576 × 50 = 28,800 lumens
- Fixtures: 28,800 ÷ 5,082 = 5.7, so six 40W lights (30,492 lumens)
Parking level, 10,000 sq ft, 11 ft ceiling
- Grid: one fixture per 625 sq ft (25 × 25 ft, as in the BPA example)
- Fixtures: 10,000 ÷ 625 = 16 lights
- Load: 16 × 40W = 640W, or 0.064W per sq ft
A real layout may need a few more fixtures for ramps, entrances and corners.
Know How Many Lights You Need?
The 40W PG02 gives 5,082 lumens, runs on 120–277V and has standard 0–10V dimming. It's DLC 5.1 Premium, which many utility rebates require, and comes with a 5-year warranty.
Shop the 40W LED Parking Garage Light →What a 40W canopy light replaces
Old fixtures are labeled by lamp watts, which say little about the light that reaches the floor. 40W LED canopy lights are commonly sold as replacements for 150W to 200W metal halide fixtures. Treat that as a rough guide, and compare lumens before you buy.
A metal halide rating is for a bare, new lamp. Some of that light is lost inside the fixture, and the lamp dims as it ages. An LED fixture's rating counts only the light that leaves the fixture.
Venture Lighting rates its 100W pulse-start metal halide lamps at 7,000 to 9,000 initial lumens. On paper, the 55W (7,054 lumens) or 60W (8,238) is the closer match. Because of fixture losses and lamp aging, a 40W may still do the job, so test one before you swap the rest.
To estimate savings, read the old fixture's label for its input watts, also called line watts. Lamp watts alone leave out the ballast.
Annual savings = (old input watts − 40) × hours per year ÷ 1,000 × your rate per kWh
Worked example, with assumptions labeled:
- Old fixture input: 125W (assumption; use your label)
- Hours: 8,760 a year (assumption: on 24/7, as many parking levels are)
- Rate: $0.15 per kWh (assumption; use your bill)
- Result: (125 − 40) × 8,760 ÷ 1,000 = 744.6 kWh, or about $112 a year per fixture
Across the 16 fixtures in the parking example, that's about $1,790 a year, before any sensor savings.
Motion sensor and dimming
An LED canopy light with motion sensor pays off where spaces sit empty for hours, like upper parking levels at night. Back entrances and storage bays are good candidates too.
For parking garages, the 2021 IECC requires lighting to drop at least 30% after 20 minutes with no activity. Our guide to garage lights vs canopy lights covers the other control rules.
Our 40W canopy light with motion sensor lists a sensor in its specs, and 0–10V dimming is standard for an external control. The page doesn't publish the sensor type, range or hold time [VERIFY]. Confirm those, and that your unit includes the sensor, before you count on the savings.
What to look for when buying a 40W canopy light
- Lumens, not watts. Look for about 5,000 lumens or more, which works out to 125+ lumens per watt. The PG02 is rated at 5,082 lumens.
- DLC Premium. Many utility rebates require a DLC listing, and Premium is the higher tier. The PG02 is DLC 5.1 Premium.
- A wet rating. Anywhere rain can reach the fixture, choose a wet-location rating. The PG02 is wet-rated and IP65.
- Controls. For spaces that sit empty, look for a motion sensor plus 0–10V dimming. The PG02 lists both.
- Colors you can order. Spec sheets often list more options than a store sells. The PG02 page offers 4000K.
- Warranty. Look for at least five years, and if the lights run 24/7, check that the terms cover it. The PG02 carries five years.
- Price. Most 40W canopy lights sell for about $44 to $165. The PG02 is $49.99 as of November 2026.
Need More or Less Light per Fixture?
If the 40W doesn't suit your ceiling height or spacing, run the lumen math above with another wattage. Green Light Depot's parking garage range has lower and higher wattages for garages, parking levels and canopies.
Compare Parking Garage Lights →FAQs
What is a 40W LED canopy light used for?
It lights low, covered spaces: parking levels with 10 to 12 ft ceilings, home and shop garages, covered walkways, entrances, carports and loading docks.
How many lumens does a 40W LED canopy light give?
Most 40W canopy lights are rated at 4,000 to 6,000 lumens. Our PG02 is rated at 5,082 lumens at 4000K, per its spec sheet.
Is a 40W canopy light enough for a two-car garage?
Not on its own. One 40W covers roughly 100 sq ft, so a 24 × 24 ft two-car garage needs about six.
What is the LED equivalent of a 100W metal halide?
On paper, a 55W or 60W LED canopy light, since a new 100W pulse-start lamp is rated at 7,000 to 9,000 lumens. Lamp ratings ignore fixture losses and aging, so a 40W may still be enough; test one first.
Does the 40W canopy light have a motion sensor?
The PG02 lists one in its specs, but the sensor type, range and hold time aren't published [VERIFY]. It also has standard 0–10V dimming for an external sensor or control.
Is the 40W canopy light waterproof?
It's IP65 and wet-location rated, so rain and water spray won't harm it, but it isn't made to be submerged. It's also rated to run from −40°F to 113°F.
The bottom line
The 40W suits low ceilings: parking levels of 10 to 12 ft, home and shop garages and covered entrances. Size it by lumens at about 5,100 per fixture, round up, and step up to the 55W or 60W when you need more. See the full specs on the 40W LED parking garage light page.

